What to Do if the Power Goes Out During Incubation: Heat-Saving and Recovery Guide

One of incubation's most dreaded moments: the power cuts out and the eggs in the machine start to cool. The good news is that a developing embryo is far more resilient than people think — in nature a broody hen leaves the eggs every day to feed, cooling them too. The wrong moves made in panic do more damage than the outage itself. This guide explains what to do during an outage, how to recover once power returns, and what to set up so you're never caught unprepared again.

First: Don't Panic, Don't Open the Lid

When the power goes, the first and most important rule is: do not open the incubator lid. A closed machine holds its heat like a blanket; every opening lets the remaining warm air escape at once. The large mass of eggs loses heat slowly — with the lid closed, the temperature drops only a few degrees per hour.

The embryo tolerates short-term cooling well. An outage of a few hours usually doesn't seriously affect the hatch rate; it may only delay the hatch by a few hours. The real dangers are long, repeated outages and high temperature — an embryo withstands overheating far less than cold.

What to Do During the Outage

1. Keep the lid closed. Don't keep checking the temperature and humidity out of worry; every look speeds up heat loss.
2. Insulate the machine. If the outage drags on, wrap the top and sides of the incubator with a blanket, towel or thick cover (without blocking the vents). This noticeably slows heat loss.
3. Warm the room. If possible, keep the room the machine is in warm with a non-electric source such as a gas or wood stove. The warmer the room, the slower the machine cools.
4. Add a hot-water bottle (for long outages). If the outage will last hours, fill capped plastic bottles with warm water (~40-45 °C) and place them inside the machine, not touching the eggs. The bottles release heat slowly and brake the temperature drop; swap them as they cool.
5. Don't worry about humidity. In a short outage humidity is not your priority; the water channels keep evaporating anyway. The only thing to focus on is preserving heat.

When Power Returns: Slow, Calm Recovery

• Run the machine normally and let the temperature return to target (37.5-37.8 °C) at its own pace. To close the gap faster, never set the thermostat above target — overheating kills the embryo in minutes; cold is tolerated for hours, heat is not.
• If you added hot-water bottles, remove them once the machine starts warming; otherwise excess heat builds up.
• If humidity dropped, bring it back gradually by adding warm water.
• After a few hours you can candle to check the embryos are still moving — but don't rush right after the outage; the embryo needs time to recover.

How Long Is Too Long?

Outage length	Expected effect
1-3 hours	Usually negligible; hatch may be delayed a few hours
3-8 hours	With insulation most embryos survive; hatch rate may dip slightly
8-18 hours	Risky; without heat retention losses rise and the hatch is markedly delayed
18+ hours	High chance of serious loss; still don't give up — check by candling

These times assume an insulated, unopened machine and a mild room. In a cold room with the lid opened repeatedly, the machine reaches critical levels much faster. However many hours pass, only hatch day and candling reveal the real outcome — don't give up early and throw the eggs out.

Preparing in Advance

• Uninterruptible power supply (UPS): Small tabletop machines draw little power; a UPS sold for computers can run most incubators for hours through short-to-medium outages. It's the most practical and quiet solution.
• Inverter + battery: Where long outages are a risk, a deep-cycle battery and inverter power the machine far longer.
• Generator: For breeders with frequent, long outages; it can also power devices that heat the room along with the machine.
• Choose the location in advance: Set the machine up in a thick-walled, stable-temperature interior space; avoid windowsills, garages or north-facing spots exposed to temperature swings.
• Keep the thermometer independent. When the power cuts, the machine's display goes dark too; a battery-powered, independent digital thermometer-hygrometer lets you see inside throughout the outage.

A Consolation from Nature

As stressful as a power cut is in artificial incubation, it helps to remember that natural incubation goes through this every day: a broody hen gets off the eggs once or twice a day to feed, and the eggs cool to room temperature meanwhile. The embryo is adapted to these short cooling periods. So an outage of a few hours isn't so different from nature's routine — as long as you preserve heat and don't overheat.

If your hatch after an outage came out lower than expected, you can find the other possible causes in our 10 reasons eggs don't hatch guide. To keep track of your incubation calendar and critical days, you can use the KuluçkaTakip app.